Facebook Email Pinterest Twitter Instagram Tiktok Icon YouTube Icon Headphones Icon Favorite Navigation Search Icon Forum Search Icon Main Search Icon Close Icon Video Play Icon Indicator Arrow Icon Close Icon Hamburger/Search Icon Plus Icon Arrow Down Icon Video Guide Icon Article Guide Icon Modal Close Icon Guide Search Icon
How-to

Troubleshooting Pressing Problems

submitted by Cecelia Podolak
from Threads #105

Pressing is one of the most important steps to successful sewing, but even expert sewers run into problems occasionally. Here are some tips that will help you get the best results when you’re at the ironing board.

Scorch removal
Add several drops of household ammonia to hydrogen peroxide that has been diluted with an equal amount of water. Use a cloth to sponge the scorched area with this mixture. Rinse well with clean water.

Pin and basting imprints
To avoid imprints in the fabric, do not press over either pins or basting (unless you have used silk or a fine cotton basting thread).

Setting or removing creases
Mix equal amounts of white vinegar and water. Apply directly to the fabric and press to set or remove creases.

Spitting iron
Lint buildup in the soleplate vents can scorch and cause brown water spotting when the iron is used on the steam setting. If you have a “burst of steam” button, depress it a few times before and after each pressing session to help clear the steam vents of lint and minerals.

Hem top imprint
When a hem is folded and pressed into position, avoid pressing over the top edge. This will prevent an imprint from showing on the right side of the garment.

Dirty soleplate
Use a tube of a nonabrasive cleaning agent recommended for irons. Heat the iron or press to the cotton heat setting and then unplug. Place a small dab of cleaner on a clean cloth or paper towel and rub onto the hot surface. Once the soleplate is clean, use a clean cloth to remove all traces of the cleaner. Be sure to use a cotton swab to clean out the steam vents.

Removing steam iron marks
The steam holes on your iron often leave little air-jet designs on your fabric. To remove them, spray-mist the area from the wrong side and lightly glide a dry iron over the marks.

Discuss

Threads Insider

Get instant access to hundreds of videos, tutorials, projects, and more.

Start Your Free Trial

Already an Insider? Log in

Log in or create an account to post a comment.

More From Threads

Discussion Forum

Recent Posts and Replies

  • |
  • |
  • |
  • |
  • |
  • |

Threads Insider Exclusives

View All
View All

Highlights

Shop the Store

View All
View More