I want to try some pattern drafting and noticed that the Lutt.System does not have facings etc. with their patterns. Is there a set rule for widths of facings like armhole, neck, front, etc. I have noticed in the commencial patterns that most facings are about the same width, but have never thought about standard measurements for facings. Any ideas or tips????
Pat
Threads Insider
Get instant access to hundreds of videos, tutorials, projects, and more.
Start Your Free TrialAlready an Insider? Log in
Sponsored Content
Replies
I really don't think that there is a "best" width. You have to take into consideration the fabrics involved. I find that a lot of commercial patterns have facings that are too narrow. I particularly like Sandra Betzina's idea of full front facings for jackets on an otherwise unlined jacket.
I am prone to making facings wider than those in commercial patterns. If I find they are too wide it is easy to narrow them.....a lot better than starting out with facings that are too narrow.
Thanks for your help. Drafting is a new experience for me and I need all the help I can get. Am excited about trying drafting as I have had a terrrible time trying to fit myself and adjust commercial patterns.
Happy Sewing,
Pat
I have to agree, with drafting, go big. I like to encase the neck and armscye together on sleeveless designs and face to the princess seam on sleeved designs. But keep in mind that I also like to interline and I don't like to line. You can go small if your putting in a full lining. If I'm doing a design where I top stitch the facing to the outside of the garment, I will use a bias strip in the armscye as opposed to a facing.
Thanks for the advice. I will try your suggestions.
Pat
This post is archived.